Unit:
|
| ①,Edge of head may be rounded or flat. ②,Screws of these lengths and shorter shall have undercut heads. ④,The diameter of body on machine screws having other than trim heads shall not be less than the Class 2A thread minimum pitch diameter nor greater than the basic major diameter of the thread. ⑤,Machine Screw Length of Thread 1) Sizes No.5 and smaller. Screws of nominal lengths equal to three diameters and shorter shall have full-form threads extending to within one pitch (thread) of the bearing surface of the head, or closer, if practicable. Nominal lengths greater than three diameters, up to and including 1-1/8 in., shall have full-form threads extending to within two pitches (threads) of the bearing surface of the head, or closer, if practicable. Screws of longer nominal lengths shall, unless otherwise specified, have a minimum length of full-form thread of 1 in. 2) Sizes No.6 and smaller. Screws of nominal lengths equal to three diameters and shorter shall have full-form threads extending to within one pitch (thread) of the bearing surface of the head, or closer, if practicable. Nominal lengths greater than three diameters, up to and including 2 in., shall have full-form threads extending to within two pitches (threads) of the bearing surface of the head, or closer, if practicable. Screws of longer nominal lengths shall have a minimum length of full-form thread of 1.5 in. unless otherwise specified. |
![Slotted 100°Flat Head Miniature Screws [Table 3] (A276, B16, B151)](https://imgcc.164580.com/upload/48/standard/2018/11/15/f2_1542258304.jpg)
